Looking for a space-saving solution in your kitchen? Convert your Panasonic 1. 2 cu ft. countertop microwave oven to a built-in model with the Panasonic NN-TK81KCS 24” microwave trim kit. This Trim Kit consists of the trim frame, an upper, lower, and rear duct that attaches to and encases the microwave inside the cabinet cut-out opening to give your kitchen a stylish look while freeing up precious countertop space. The Panasonic NN-TK81KCS Trim Kit is designed for use only with the NN-CD87KS Panasonic Microwave Ovens. For safety, unplug the microwave oven before attempting installation of the NN-TK81KCS trim kit. Installation of this trim kit requires basic mechanical and electrical skills and may be completed by the DIY homeowner or kitchen cabinetry professional. Proper installation is the responsibility of the installer. The microwave oven must be used with a properly grounded 3-prong receptacle in compliance with the National Electrical code, as well as any applicable local regulations. Also refer to the microwave oven operating instructions for other safety and electrical requirements. This trim kit is only compatible with Panasonic Microwave Ovens.
Microwave Oven Replacement Parts
Panasonic 24-inch Microwave Trim Kit, Stainless Steel, for use with 1.2 cu ft NN-CD87KS Panasonic Microwave Oven – NN-TK81KCS
$4.20
| Asin | B089CCLSVS |
|---|---|
| Dimensions | 23.5 x 0.75 x 16.13 inches |
| Weight | 7.71 pounds |
| Manufacturer | Panasonic |
Dewey Bumstead –
At first blush, this may seem to be very pricey for a microwave trim kit. However, there is more to the kit than just the exterior trim.
1. This includes vent conversion hardware that is necessary when installing the microwave in a wall cabinet.
2. This kit includes a mounting platform that the microwave rests on.
3. Finally, the kit contains the SS trim that snaps on to complete the installation.
This kit is well designed and engineered. However, the instructions are atrocious! They diagram 3 different installation options without describing the differences. All 3 diagrams have a typo (see photo) if you want a proper conversion from metric to imperial. No problem, one of my tape measures has both. It turns out that the recommended opening width of 600mm IS WRONG. I only discovered this after cutting the opening and installing the trim…. I have about a 3/16″ gap on both sides. I plan on adding stainless steel angles to fix the appearance but better instructions from Panasonic are needed.
PS: You should know that the installation instructions show a 1-1/2″ gap in every shelf in the cabinet including the top. I am guessing that this allows the microwave to draw a proper volume of air in and to exhaust air out. I used a forstner bit to drill equivalent holes in every shelf and into the upper bulkhead. Again, the diagram shows this without explaining it in English.
NETexas –
Looks nice and is well made, but the side width isn’t wide enough to completely cover the mounting clips. They show a little, not too bad but if you look close enough they can be seen.
William L. Vincent –
I had to do some remodeling of the kitchen cabinet opening to make this work, but the result is great. Very nice looking.
Savonne Deo –
You’ll definitely need to be handy to install this bracket for your microwave. Does look good after couple hours. Instructions need to be more specific.
Carrie o. –
The frame and associated parts were easy to install and looks great. Only issue was the amount of time it took to get this in.
Amazon Customer –
Very good product
geekworld –
at 24-inch this is too small
I wish it was available larger (i.e. 27-in)
Other reviewers are right, the instructions are complicated and confusing
Overall low value
Unsatisfied customer –
The rough opening width is wider then the trim kit. Very unprofessional and tacky look.
D. Braga –
The Panasonic trim kit (which I bought used on Amazon) was well packaged and included all the parts with no damage. However, I knew the 24 inch trim was not going to work for me so I also bought this kit. Cosmo COS-30BIMTK 30 in. Stainless Steel Microwave Oven Built-In Trim Kit… which worked better even though it was intended for a wider oven. I used left over trim from the cabinets to hide the openings and it looks ok. It would be nice if Panasonic offered this trim plate.
Dylan Cook –
Very attractive trim. Fits perfectly and was very easy to install.